For more than 40 years, there has not been a way to use one component foam sealant to spray, until now! Introducing the Spray Sealants Gun. This simple solution uses pressurized air to create spray sealants which will save you time and money on every project. It’s compact, easy to operate and great for all those hard-to-reach areas in which traditional foam kits cannot be easily used. Also, because you are using a one component foam sealant, each application is affordable. The Spray Sealants Gun is truly a handy addition for your energy efficiency toolbox.
The Spray Sealants Gun for Canisters allows for application of spray sealants from a 10 lb or 16 lb Canister. This means that all of those larger projects that used to require a foam kit, can now be applied faster and more affordably. Also, because the Spray Sealants Gun volume can be controlled through the air compressor you can change the amount of material that you are spraying in a matter of seconds.
Traditionally, there have only been two choices: Bead application and spray application. Some one-component polyurethane materials are easy to apply but are not designed for spraying. For sealing joints, seams or cracks, a one-component foam or canister sealant has been successfully used for 40 years. Projects that require a two-component foam kit are usually more complicated and expensive. While bead application has been effective solution, it is not as effective as a spray application. Bead applications must often be re-sealed over time and do not penetrate all of the deep surface cracks gaps and crevices, or microscopic areas that are difficult to see or reach. Spray sealant applications expand sealing cracks and crevices deeply and thoroughly when applied correctly. This means that spray applications are more effective, and projects are not likely to require any repeat application. Another property of spray sealants and is that they cure upon reaction--much faster than the bead method. Therefore, surfaces can be restored for use quickly.